Jet Mill of Potassium Carbonate

In this economically flourished area, there are many people who know the airflow pulverizer, Jet Mill of Potassium Carbonate technology leads in the same industry.

Jet Mill of Potassium Carbonate has a wide range of smudges, simple and convenient operation, but during the pulverization process, there is often a case where the crushing effect is different.

The crushing effect is mainly affected by the following factors:

The temperature and pressure of the gas ratio, the feed particle size, the working fluid, and the pulverization aid. The gas-solid ratio of the pulverizer in crush is an important technical parameter and an important indicator. If the gas is too small, the kinetic energy of the airflow will be insufficient, which will affect the fineness of the product. But if the gas is too high, not only will waste energy, but will even degrade the dispersion performance of certain pigments. When pulverizing hard materials, there is a stricter requirement for the particle size of the feed. In terms of titanium powder, it is necessary to control 100 to 200 mesh when pulverizing calcination; the material after pulverizing surface is generally 40 to 70 mesh, and cannot exceed 2 to 5 mesh. So, should you choose how high pressure when crushing? Those skilled, this is mainly dependent on the comminutability and fineness requirements of the material.
Jet Mill of Potassium Carbonate Working: The material is homoked by the feeding, and the pulverized mouth is fed in an appropriate amount. Under the action of the fixed knife and the rotary knife, the various straw is cut into a small section, then Enter the crushing room, under the strong hit of the high-speed hammer, the material is rapidly pulverized, and the pulverized material falls into the screen due to the large amount of wind pressure and a large amount of wind pressure in the built-in fan. The cavity is sent from the wind pressure transfer pipe to the aggregate room.

Jet Mill of Potassium Carbonate will generate certain noise during production, the main reason for generating noise is:

(1) When the coal is running at high speed, the operating part drives air to generate \"whistle\" Call:

(2) The device is running. Generate vibration sound; (3), the friction between the turntable or the hammer and the drug; the rotating part itself is friction.

For the cause of noise, the main solution is as follows:
(1) adding oil to each rotating member, if the bearing and the axis are misalign, adjust the bearing wear, replace the bearing;
( 2) The heat generated during the breaking process also produces noise, and cools the cooling of the crushing chamber, the muffler is mounted in the air intake port of the pulverizer; (3) damping the damping pad and other devices.

AlPa Precipitated Sulfate Jet Mill of Potassium Carbonate Case Sharing: Shenzhen Chemical Raw Material Company requires multiple large production, low particle size precipitated sulfateCrush production line.Our AlPA is a large enterprise in the powder equipment industry, and our equipment is customized.Different companies are used to meet different needs of different companies.In response to the needs of the company, our company customizes five Jet Mill of Potassium Carbonate, large mechanical crusher production lines to meet the customer's production needs.

Technical parameters:

Finished granularity: D50: 0.8-5μm
Production capacity: 4.5 +/- 10% / T


Jet Mill of it is to bringPotassium carbonate uses matters, you want to know more about other crushers, you can pay more attention to us!