DISC JET MILL OF SLAG

In the faster development, there are many people have a certain understanding of the DISC JET MILL OF SLAG, and the crusher technology is in an absolute leading position in the industry.

Generally, the high-speed airflow accelerated pulverized solid particles have the following three ways:

(1) Airflow particles accelerate nozzle: After the airflow and the particles are mixed, the particles can be obtained. Very high speed (almost the same speed of airflow speed), but the material wears in the nozzle in the nozzle, rarely used in practical applications.
(2) Syringe Acceleration Particles: High Speed \u200b\u200b(Ultrasonic Speed) airflow and particles mix accelerate in the mixing tube, the particles obtain a higher speed, but the material is severe to the mixing tube.
(3) Free airflow acceleration particles: particles enter the high-speed airflow in the form of freely drop, only the high-speed air flow is passed through the nozzle and the wear is small.


What is the grading principle and process of DISC JET MILL OF SLAG? Below, here, share it with you.
1. Open the switch in the control cabinet, start the power supply, equipment operation;
2, the raw material enters the feeder

4, the raw material reaches the hierarchical body after special dispersion, grading through physical effects such as airflow and gravity;
5, the airflow of the three flow paths has the control valve group adjustment to maintain their respective balance;
6, grading The rear coarse fine product is recovered separately;
7, clean air is discharged into the atmosphere.

In general, there are some sounds in the operation. DISC JET MILL OF SLAG will definitely have broken sounds when crushing raw materials, which is normal. However, if the sound turns a noise, if the sound becomes too loud, it will become a problem. So how do I solve the phenomenon of excessive noise? Let's take a look at it.
1. Add a lubricating oil on the rotating part, and adjust the bearing if the bearing and the shaft are; if the bearing wear is resistant, the bearing will be replaced.
2. There will be noise during the pulverization process. The cooling sleeve is dispensed in the crushing chamber, which can be used to reduce the temperature.

4. Damping equipment, such as using damping boards.


ALPA Avative Glucose Media DISC JET MIET MILL OF SLAG Case Sharing: A starch sugar company needs a device that dispelling the water glucose medium, which is very investigated.Many powder companies have not found appropriate equipment.We have found appropriate equipment in our AlPA.Our DISC JET MILL OF SLAG can disperse the water glucose medium.
Technical parameters:
Finished particle size: waterless glucose greater than 18 mesh

Shandong AlPa supplies a variety of DISC JET MILL OF SLAGs.If you need to purchase DISC JET MILL OF SLAG, please feel free to contact us.