Steam Jet Mill for Dichloromethane

With the continuous development of pulverizer technology, STEAM JET MILL for Dichloromethane has gradually penetrated into everyday life.

In terms of airflow milling, it is important to understand its operational rules, which is very important because only familiarize the procedure, can operate correctly.
1. The operation rules of Steam Jet Mill for Dichloromethane are as follows: Prepare materials after the preparation before the boot is received. Complete the site to clean the grocery. Check whether the transportation pipes and auxiliary equipment, whether the pipelines are blocked, leak or poor sealing, whether the auxiliary equipment is intact, whether it works normally. Whether there is a phenomenon that the material is accumulated in the outer casing and the separator, if the accumulated material is required. Whether the bearing is lubricated, whether it is lubricated in an appropriate place. Check if all pipes, fastening bolts, washers, spindles, and instruments are intact, normal and flexible.
Second, Steam Jet Mill for Dichloromethane starts the motor, control the current and time at starting, so that the device can start running. When the equipment is operating normally, the feed speed can be adjusted according to the properties of the material. Uniform continuous feed should not be large or small, thereby affecting the separation effect of the grinding machine, making the machine easily malfunction. During operation, if an abnormality occurs, stop checking immediately before the failure continues.
Three, Steam Jet Mill for Dichloromethane's closed and inspection The main procedures are as follows: After the material in the grinding machine housing is completely pulverized, it should stop feed and turn off the motor. After the machine is idling for 3 minutes, press the stop button to stop the machine. When the machine is completely stopped, open the check door and check the wear of the vessel. Fill in the corresponding production record, update the device status flag, which is convenient for the next use.

The features of Steam Jet Mill for Dichloromethane are:

1. High yield, low energy consumption, high grading efficiency.
2. Particle size: This machine uses impeller to grade. Stable classification process and special sealing measures effectively prevent the leakage of crude particles, so that the product has no large particles, the particle size is concentrated, and the grading accuracy is high.

4. Strong applicability: Can form closed or open joint operations with various mill (air mill, mechanical mill, ball mill, thundering machine, vibrating mill, etc.).
5. High degree of automation.
Steam Jet Mill for DichlThe bearing maintenance of the OrometHane bearing component is prone to malfunction, which is larger in use, so you need to regular maintenance, often refuel to increase the life of the bearings. The impact crusher is maintained daily to ensure that the crushing equipment is in good technical state, and can be operated at any time, shorten the residence time, improve the integrity of the crusher, reduce the wear, and extend the life of the crusher; Maintenance, mandatory, correct processing, maintenance and repair is not allowed to be used alone.

AlPa Kaolin Steam Jet Mill for Dichloromethane case sharing: The customer is a Kaolin Powder company in India. The customer needs a grading equipment to select the kaolin ultrafine powder. It has been investigated a lot of companies. suitable. Finally, our AlPA meets the customer needs for the classifier equipment provided. The set of equipment has reached 4T per hour.
Shandong AlPa focuses on the production, research and development, sales of powder engineering equipment and other powder engineering equipment and other powder engineering equipment, the production of small ultra-fine pulverizer is three parts: mainframe, auxiliary machine, electric control It consists, the gas flow is pulverized, the airflow classification, the mechanical powder is integrated, flexible to realize the gas flow, airflow grading, mechanical powder is integrated, 325 mesh-10000 mesh (45μm), suitable for a variety of crushing scenes, from research institutes, College laboratories, new products and tests in the factory research institute. It is necessary to make the device selection according to the actual needs. Welcome new and old customers to come to consult!