Jet Mill of Modified Starch

With the development of society, the application of Jet Mill of Modified Starch has become more large.

High-speed jet enters the crushing chamber, collides with particles, multiple times in the friction of high pressure air, shear and pulverized, pulverized materials, and the assembly of rising airflow motion, under the action of the fan, At the power of the rotational speed of Jet Mill of Modified Star, the thickness of the material is separated from the separation, the fine particle size of the graded wheel into the cyclone separator and dust removal, the pulverization region of the crude particles continues to be pulverized. The classifier produced by AlPa can perform local internal changes depending on the different characteristics of the material, so that it is more suitable for the grading requirements of the material. The grading machine has a greater processing amount, energy saving, simple operation, and low maintenance cost.

Jet Mill of Modified STARCH can be used in series with a multi-stage classifier and produced a product having multiple particle sizes. The device is easy to disassemble, the inner wall is smooth, and there is no dead angle. The whole system is closed, the dust is small, low noise, and the production process is clean and environmentally friendly. The control system uses program control and easy to operate.

For the long-term \"health\" of the equipment, we need to take some steps to protect them again.

1. First, the gap of the hammer screen can be adjusted: the friction on the screen changes varies from the distance between the material and the screen, and the friction is different. Improve the hammer speed and hammer material efficiency by adjusting the hammer net gap. However, during the production process, the screens they use are different, the raw materials are different, the hammer screening gap needs to be adjusted; in the crusher, the crusher is not very good at the beginning, but after a period of time Work, the particles inside the crusher also changes; in the grinding machine parts, the hammer head is easily worn, and the gap between the hammer head and the screen is increased, and the yield is also declining, it is difficult to maintain.

Of course, in order to test the yield of a crusher, for some of the raw materials, for some screen holes, in order to determine the appropriate hammer sieve gap and suction, the useful life of the screen and the hammer can be obtained in a short time. Very high grinding efficiency data. However, in the production of feed grinding, such specific measurement data, according to the operator's work experience, the technical content of the crusher itself is two things. People with enrichment of experience and labor experience also require higher operating costs. When the hammer is worn, the gap between the hammer and the sieve increases, the friction is reduced, and the abrasive efficiency is lowered.
2.Jet Mill of Modified Starch mainly requires a reasonable use of reverse glitch: mainly to rush the side hair of the screen into the inside, greatly increase the friction, but this method is not used for a long time. After the globi polishing, the efficiency is lowered. It lasts for 30 minutes to 1 hour.
3. Put the friction piece into Jet MIll of Modified Starch: The frictional sheet has the effect of material ring, but the effect is limited. First, the teeth of the friction plate are in front of the hammer head, the friction surface is small, and the hammer is long-lasting; if the sieve area is too small, the output screen area will be reduced.
For any of the equipment, everyday maintenance can be performed, to ensure that the equipment can operate for a long time, so daily is critical to Jet Mill of Modified Starch.

ALPA Paint Slag Jet Mill of Modified Starch case Sharing: The customer is an investigation of similar domestic companies, and did not find a crusher that can smash the paint slag. Finally, I know that our Shandong Alpa is a non-standard custom-made enterprise that is a super-smashing equipment, and I have found us. We have repeatedly tried, and we found a super-pulverizing machine suitable for crushing paint slabs. Finally, the customer purchased our company's Jet Mill of Modified Starch, the most crushed oil paint slag.
Technical parameters:

finished particle size: D90: 800 目

Production capacity: 800-1000kg


Is it more than the Jet Mill of Modified Starch more understood. For more information, continue to pay attention to our website.