Hammer Mill of Plastic antioxidant

Hammer Mill of Plastic Antioxidant is a very convenient device that can be used to crush all kinds of products, especially some fine particle products need to be used.

Hammer Mill of Plastic Antioxidant mainly used Abstract material. The pulverized particle diameter is 1.5 to 0.005 mm, and the crude material is sieved.
The principle of pulverization is substantially the same as the hydraulic level, and the above settlement theory can also be used for airflow classification. However, in the airflow classification, since the density and viscosity of the air are much smaller than the density and viscosity of water, the same particles are more settled in the air than in the water. Moreover, the density and viscosity of the air vary with temperature and pressure.

In order to cause air flow, wind pulverization equipment typically requires an appropriate fan (exhaust or blast).

When the airflow is classified, the fine product is usually taken away by the airflow. In some cases, the raw material is sent to a pulverized device from the airflow.

As is well known, the load of solid particles in the air under normal pressure does not exceed 500 g / m3 air. When it reaches 1 kg / m3, the particles fall from the airflow. The load is related to the density and particle size of the particles. When the fine particle material is treated, the load generally does not exceed 200 to 300 g / 3 air. According to this calculation, the volμme concentration in the gas stream is much smaller than 0.03. Therefore, when the airflow is classified, in most cases, it belongs to the free settlement.

The speed required to move the particulate material in the horizontal and vertical direction is relatively large, and the speed required in the horizontal direction is relatively large, and as the particle density increases, for example, for the density 1.5 of the pulverized coal and Western / cubic centimeter. The minimμm wind speed is 2 m / sec; a powder material having a density of 2.5 g / cm, the speed is not less than 3.5 m / sec; a powder having a density of 4 g / cm 3, a minimμm speed of 4 meters per second. Due to the complexity of the situation, the appropriate airflow rate in each particular situation should be determined by experiments.

In the rising airflow, the water flow rate required to suspend a certain density and particle size is greater than the calculated value of free settling, which is due to the uneven distribution of the airflow along the pulverizing chamber portion.

The Hammer Mill of Plastic Antioxidant has a wide comminuted range, high pulverization efficiency, high pulverization accuracy, accurate cutting particle size, and good stability.
ALPA Gao Pure Stone Powder Hammer Mill of Plastic Antioxidant Case Sharing:

The company has strong technical strength, advanced testing instrμments, perfect pre-sales, sale, after-sales service.
The company continues to improve and improve product quality, adopted IS09001: 2008 international quality management system certification, the company strives to meet customer requirements with excellent product quality and quality service.
Case parameters:
Product particle size: D50: 3.5μm
Hour Yield: 800kg

Companies consistently follow the standard management, put quality in front of the production and service policy, provide customers Reassuring products and services with a weighing airflow crusher.